martensite

1. Microstructure and Properties of Welded Joint of Cast Martensite Stainless Steel
   马氏体不锈钢铸件焊接接头组织和性能分析
2. Phase transformation from austenite to martensite in NiTi alloy strips under uniaxial tension has been observed in experiments and has been numerically simulated as a localized deformation.
   单向拉伸镍钛合金带中从奥氏体到马氏体的相变已在实验中观测到，并被看作为局部变形进行了数值模拟。
3. Effect of deformation induced martensite on Electrochemical Behaviors of Type 304 stainless steel in the active state
   形变诱发马氏体对304不锈钢在活化状态下电化学行为的影响
4. The relationship between fracture toughness and notch toughness, tensile ductilities in lath martensite steel has been investigated.
   研究了超高强度板条马氏体钢的平面应变断裂韧性与缺口韧性、拉伸塑性之间的关系。
5. The deformation dislocation density and martensite microstructure were also analysed by TEM.
   采用TEM对形变位错密度以及马氏体组织进行了分析。
6. There ate a small amount of martensite in HAZ, and distributed in gradient.
   热影响区中存在少量细小马氏体组织，且呈梯度分布。
7. Progress in Chemical Composition, Process and Corrosion Resistance of Martensite Stainless Steel
   马氏体不锈钢成分、工艺和耐蚀性的进展
8. Matrix Structure of Martensite and Bainite in Steels
   钢中马氏体和贝氏体基体组织的特征
9. Effect of strain rate on strain induced α′-martensite transformation and mechanical response of austenitic stainless steels
   应变速率对奥氏体不锈钢应变诱发α′-马氏体转变和力学行为的影响
10. Grain Boundary Martensite Formation and Tempering Brittleness at Low Temperature of Steels
    钢的晶界马氏体形成与低温回火脆性
11. With the help of X-ray diffraction technique, thermal-induced martensite transformation in304 austenitic stainless steel was investigated.
    借助X射线衍射技术，研究了304奥氏体不锈钢热诱发马氏体相变倾向。
12. Effect of Martensite Volume Fraction on Deformation Dislocation Structure and Fracture for Hot Rolled Dual-Phase Steel
    马氏体体积分数对热轧双相钢形变位错结构和断裂的影响
13. Study on strain-induced martensite transformation of 304 stainless steel during ratcheting deformation
    304不锈钢棘轮变形过程中应变诱发马氏体相变行为研究
14. In this paper, influence of remnant field intensity resulted from grinding process on friction coefficient of martensite stainless steel in the condition of short-time dry friction was investigated.
    本文研究了马氏体不锈钢磨削加工产生的剩余磁场对其短时干摩擦过程中摩擦系数的影响。
15. A solid solution of ferric carbide or carbon in iron; cools to form pearlite or martensite.
    含铁碳化物或含碳铁的固体溶体，冷却可形成珠光体或马氏体。
16. Effects of Aging Temperature on Performances of Martensite Precipitation Hardening Stainless Steel
    时效温度对新型马氏体沉淀硬化不锈钢性能的影响
17. Furthermore, both the effect of martensite lath boundaries on the nucleation of dynamic recrystallization, and the mechanism of nucleation and growth of equiaxial nanometer grains were revealed.
    揭示了马氏体板条界面在温变形过程中对动态再结晶形核的作用，及退火过程中等轴纳米晶粒的形成机制和长大机制。
18. The experimental results show that ultrafine grained austenitic stainless steel can be obtained by the reversal transformation of deformation-induced martensite.
    本文研究了热处理对冷加工奥氏体不锈钢组织的影响，试验结果表明利用形变马氏体的逆转变可获得超细化不锈钢晶粒。
19. Transformation of martensite into a network of chromium carbides.
    从马氏体转变成网状的碳化铬。
20. The influence of diffusion activation energy of carbon atom and tempering time on tempering transformation of martensite are studied by using of the principle of carbon diffusion in martensite.
    根据马氏体回火过程中的碳原子扩散特征，分析和计算了碳扩散激活能和回火时间对马氏体组织的影响。
21. Erosive Wear of High-Cr Cast Iron With Austenite or Martensite Matrix
    奥氏体基体和马氏体基体高铬铸铁的冲蚀磨损特性
22. The final structure obtained from tempering a fully hardened steel is called tempered martensite.
    回火完全淬硬钢得到的最终组织结构被称为回火马氏体。
23. Effect of Lath Martensite Morphology on the Mechanical Properties of Steel
    条状马氏体形态对钢力学性质的影响
24. Influence of Copper on Antibacterial Property and Mechanical Property of Low-carbon Martensite Stainless Steel
    铜对低碳马氏体不锈钢抗菌性和力学性能的影响
25. Microstructure and Mechanical Properties of Cold-rolled Low-carbon Martensite after Annealing
    冷轧低碳马氏体的退火组织及力学性能
26. It ′ s found that martensite transformation in1J30 is irreversible by analyzing the heating and cooling process of1J30.
    对1J30升温和降温过程分析得出，深低温条件下1J30的马氏体转变为不可逆转变。
27. X-Ray analysis finds that steel after tempering main matrix of tempered martensite.
    用X-射线衍射分析发现，试验钢回火后的组织主要为回火马氏体。
28. Effect of martensite volume fraction on deformation dislocation structure and fracture for hot rolled dual-phase steel of the same composition was studied by using SEM and TEM.
    文章利用SEM、TEM研究了热轧双相钢单向拉伸过程中不同变形量下的形变位错结构和断口组织特征。
29. Effect of Si on the Wear Resisting Steel of Medium Carbon Low Alloy with Bainite and Martensite Composite Phase
    硅对中碳低合金贝氏体/马氏体复相耐磨钢的影响

noun

1. a solid solution of carbon in alpha-iron that is formed when steel is cooled so rapidly that the change from austenite to pearlite is suppressed