g/cm
英
美
网络 克/厘米
双语例句
- It has a horrendous density of ten g/ cm^ 3 to the14th grams per cubic centimeter.
它的密度是惊人的，10的14次方。 - The results show that: the foam has a density range of 0.10 to 0.22 g/ cm~ 3 and the cell size varies from 4.0 to 11.0 mm.
研究结果表明：泡沫铝的胞直径范围为4～11mm，密度范围为0.10～0.22g／cm~3。 - The density of AlON is 3.63 g/ cm 3, about 97.8% of its theoretic density.
所制得AlON试样的体积密度为3.63g/cm3，约为其理论体积密度的97.8%。 - 200 μ g/ cm~ 2 free-standing Zr filters of 20 mm in diameter were made by DC magnetron sputtering.
利用直流磁控溅射方法制备了质量厚度为200μg.cm-2，直径为20mm的自支撑金属Zr滤光膜。 - A pot culture experiment was conducted to investigate the effects of soil with different bulk densities ( 1.2 、 1.4 and 1.6 g/ cm~ 3) on the growth, yield and nutrient uptake of cucumber plants.
用容重分别为1.2、1.4和1.6g/cm3的土壤进行盆栽试验，研究了土壤紧实度对黄瓜生长、产量及养分吸收的影响。 - Therefore, both the impregnating efficiency and properties of C/ C composites can be well improved. The density of C/ C composites can reach 1.61 g/ cm~ 3 after six times impregnation-carbonation.
以改性后的煤沥青为浸渍剂对C/C复合材料进行增密处理，经六次浸渍-炭化后，C/C复合材料的密度可达到1.61g/cm3以上。 - The containing water of microencapsulated lutein was 3.0%, density was 0.39 g/ cm~ 3, diameter was 8~ 10 μ m, solubility was 90s.
结果表明，微胶囊叶黄素含水率为3·0%、密度0·39g/cm3、粒径8~10μm、溶解度90s； - / cm~ 2 and the yearly mean biomass is 391 μ g/ cm~ 2 in Station ⅰ.
/cm~2，年平均生物量为量为391μg/cm~2； - When polymerization temperature was in the range of 30-80 ℃ and ethylene pressure was in 0.12-0.72 MPa, the polymerization activity increased as temperature and pressure while the bulk density of the polymer decreased from 0.27 g/ cm~ 3 to 0.22 g/ cm~ 3.
聚合温度在30～80℃和乙烯压力在0.12～0.72MPa时。随着温度和压力的提高，聚合活性增加，聚合物堆密度由0.27g/cm~3降低至0.22g/cm~3。 - The optimum technological conditions for the granulation are these: the solution density of 1.82~ 1.83 g/ cm~ 3, temperature of 140~ 146 ℃.
最佳的硝酸铵钙母液造粒工艺条件为：溶液密度1.82～1.83g/cm3，温度140～146℃。 - The density of C/ C composites can exceed 1.70 g/ cm~ ( 3) after impregnation/ carbonation for six times.
在经过6次浸渍/炭化处理后，C/C复合材料的密度可达到1.70g/cm3以上。 - HVC is a new manufacturing technique, for producing high density ( 7.4 g/ cm~ 3~ 7.8 g/ cm~ 3) P/ M parts efficiently at low cost.
HVC技术是一项低成本、高效率成形高密度（7.4~7.8g/cm3）粉末冶金零件的新技术。 - The sedimentation rate, which was average 0.13 ± 0.01 g/ cm 2. a, was stable in the Bosten Lake by analysing the mass depth and ages.
通过质量深度与年代分析，博斯腾湖的沉积速率相对稳定，平均沉积速率为0.13±0.01g/cm2.a。