With the DRB in ohmmeter mode, measure the ground circuit. 用DRB的欧姆计模式,测量接地电路。
With the DRB in voltmeter mode, probe the RR decay solenoid control ckt. 将DRB置为电压表模式,测试右后衰减螺线管控制CKT。
With the DRB in ohmmeter mode, probe the RR ckt. 用DRB的欧姆表模式,检测右后CKT。
Connect the DRB scan tool to data link ( diagnostic) connector. 将DRB扫描工具连接到数据链路(诊断)接头。
Connect the DRB to the vehicle data link connector. 把DRB连到汽车数据链接接头。
With the DRB read the active codes. 使用DRB读活动代码。
With the DRB in ohmmeter mode, probe the system relay output circuit. 当DRB处于欧姆方式时,检测系统继电器输出电路。
With the DRB read the seat belt switch status. 使用DRB读取安全带开关状态。
With the DRB select monitor display "wiper system" monitor the wiper Park switch. 用DRB选择监视器显示雨刷系统监视雨刷停止开关。
With the drb, read the intermittent wiper sensor voltage. 用DRB读间歇的雨刷传感器电压。
Ensure that the ignition is on, and with the DRB, erase all diagnostic trouble codes. 确保已经点火,用DRB,擦去所有诊断故障码。
With the drb, select abs, read the traction control switch state. 使用DRB,选择ABS,读牵引控制开关状态。
Refer to the DRB users guide for instructions and assistance with reading trouble codes, erasing trouble codes, and other DRB functions. 参考DRB用户指南,依照其上的指导读取故障代码,清除故障代码和执行其它DRB功能。
With the DRB erase trouble codes. 用DRB消去故障代码。
Press DVOM button on DRB. 按下DRB上DVOM按钮。
Note: the DRB is still reading the OD pressure switch status. 注:DRB仍然在读OD压力开关状态。
Depress and hold the brake pedal, with the drb, actuate the left rear hydraulic. 蹋下并保持刹车踏板,用DRB引动左后液压。
With drb, select 2nd gear clutch test. 利用DRB,选择2挡离合器测试。
With the drb, read the LF door ajar state. 用DRB读左前门的微开状态。
With the drb, select sensors, read the ignition voltage. 对于DRB,选择感知器,读出点火电压。
With the drb, read the door lock switch voltage. 用DRB读一下门锁开关电压。
Turn the ignition off, then turn ignition on, put the DRB in voltmeter mode. 熄火,然后点火,置DRB于伏特表模式。
With the drb, erase the diagnostic trouble codes. 用DRB,删除诊断故障代码。
With the drb, actuate door unlock and observe the test light. 用DRB触发门开锁继电器并观察测试灯。
With the DRB in voltmeter mode, probe the ABS system relay control ckt. 用DRB的伏特计模式,探测ABS系统继电器控制电路。
With the DRB read the status of the airbag warning lamp and note the state of it. 用DRB读安全气囊警示灯的状态并注意它的状态。
With the drb, perform a quick battery disconnect. 利用DRB,完成快速电池断开。
While monitoring the drb, gradually move the wiper switch from the off to hi position. 同时监看著DRB,并逐渐的将雨刷冲关闭状态移动到高速状态。
With the drb, read HVAC control head voltage. 用DRB,读取HVAC控制头电压。
With drb, check clutch volume index ( cvi). 用DRB检查离合器油量指数(CVI)。